Lenco Bennett Retrofit Kit - 24V [15065-001]
Bennett RetroFit Kit
We make the best boats better!
Lenco Marine Electric RetroFit Kit for Bennett Trim Tabs
Upgrade your boat with the latest trim tab technology - trouble-free, high performance Lenco electric actuators.
- Use existing Bennett trim planes, lower bracket and switch
- Use all existing mounting holes
Lenco RetroFit Kit includes:
- 2 electric actuators
- 2 upper mounting brackets
- Switch wiring kit
- All mounting hardware
- Lenco wire feeds through existing oil line hole in transom
- Lenco upper mounting bracket fits existing Bennett mounting holes
- Existing Bennett trim tab plane and hinge
- Existing Bennett lower bracket
Just 4 Simple Steps:
- Remove Bennett actuators, and install Lenco upper mounting brackets on transom
- Feed Lenco wires through holes in brackets and through existing oil line holes in transom
- Mount Lenco actuators on to new upper brackets and existing Bennett lower brackets
- Connect Lenco actuator wires to existing harness.
WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
We Also Recommend
Rule 1100 GPH Electronic Sensing Bilge Pump - 24V [27SA-24]
Ocean Signal rescueME EPIRB1 - Category 2 [702S-01540]
Navico XSONIC B150M 20 TH 9-Pin Connector w/10M Cable [000-13922-001]
Coleman Northern Nova Propane Lantern