C.E. Smith Backing Plate f/80 Series Rod Holders 
Backing Plate f/80 Series Rod Holders
Backing plates are very important to have under every rod holder used for heavy tackle fishing. When the rod holder is under extreme load, regular nuts and washers can concentrate stress and cause spider cracking around your rod holders or perhaps even tear through causing severe gunnel damage. Smith backing plates distribute mounting bolt pressure evenly over 30 times more surface area than with standard washers alone. 2 sizes, one for 70 series and 80 series rod holders. Each size fits all 3 models of the series.
- Use this backing plate on all 80 series rod holders (53680CA, 53680SA, 53681CA, 53681SA, 53682CA, 53682SA)
- 316L cast stainless steel
- 4-1/4" x 6"
- 4mm thick
- Use your 1/4" stainless bolts and nuts (hardware not included)
We Also Recommend
Rule 1100 GPH Electronic Sensing Bilge Pump - 24V [27SA-24]
Ocean Signal rescueME EPIRB1 - Category 2 [702S-01540]
Navico XSONIC B150M 20 TH 9-Pin Connector w/10M Cable [000-13922-001]
Coleman Northern Nova Propane Lantern